关于热力学、热量传递和质量传递,以及流体工程的 A-Z 指南
中文 English Русский Português Español Français Deutsch 关于我们 编辑 联系我们 访问 Begell House
View in A-Z Index

A Benson boiler is a type of Once-Through Boiler patented by Marc Benson in Germany in 1923 and incorporates recirculation characteristics at part-load operation below about 60° MCR.

The Benson boiler usually consists of small diameter tubes (ca. 25 mm bore) spirally wound to form the furnace envelope. Feed water enters the bottom of the furnace at high sub-critical or supercritical pressure and is evaporated to high quality in the spiral section. A balancing header is commonly provided near the top of the furnace to alleviate any differences in steam quality resulting from variations in heat absorption in different parallel spiral circuits before the steam/water mixture is introduced to the open boiler pass. Here, it is superheated in the upper parts of the furnace envelope and subsequently in pendant tube banks. The balancing header also serves as a means of separating excess liquid when, at low loads, the furnace flow rate exceeds the steam demand from the boiler as a whole. As in other forms of Fossil Fuel-Fired Boilers, the flue gasses are used for reheat, economizer and air-heating duties.

Along with other types of Once-Through Boiler, the convective heating surfaces may be mounted either in a vertical up-pass above the furnace (a tower boiler) or in a horizontal and vertical down-pass behind the furnace (a two-pass boiler). Illustrations of both types appear in the article on Once-Through Boilers.

浏览次数: 35344 创建日期: 2 February 2011 最后修改日期: 10 February 2011 © Copyright 2010-3921 返回顶部
A-Z 索引 作者/编辑 语义地图 视觉画廊 贡献 Guest